Standard Number:  AGMA 6001-D97-1997

Title:  design and selection of components for enclosed gear drives

Language:  English

Replaced by Standard:  

Replacing Standard:  

Publication Date:  1997-1-1

Execute Date:  2000-1-1

Revocatory Date:  2000-1-1

Adopted International Standard:  

Status:  

Standard Type:  

Publisher:  American Gear Manufacturers Association(AGMA)

Price:  

Number of Pages:48  

Preface:  

Description:This standard provides an acceptable practice for the design and selection of components for enclosed gear drives. Fundamental equations provide for the proper sizing of shafts, keys, and fasteners based on stated allowable stresses. Other components are discussed in a manner to provide an awareness of their function or specific requirements. This standard applies to the following types of commercial and industrial enclosed gear drives, individually or in combination: spur, helical, herringbone, bevel and worm. 1.1 Exceptions The equations in this standard are not applicable when gear drives are subjected to vibratory conditions where there may be unpredictable fatigue failure. The procedure for design or selection of the specific gear components is varied and complex and is beyond the scope of this standard. Designers must refer to the specific rating or enclosed drive standards for this aspect of drive design. 1.2 Intended use The equations and values presented provide a general approach to design. Deviations from the methods and values stated in this standard may be made when justified by experience, testing, or more specific analysis. It is intended for use by experienced gear designers capable of selecting reasonable values based on their knowledge of the performance of similar designs and the effect of such items as lubrication, deflection, manufacturing tolerances metallurgy, residual stresses, and system dynamics. It is not intended for use by the engineering public at large.  

Overview:  

Cross References: